Answer up front

Published third-party data puts well pump in the 975–2,821 dollar range nationally — Depth is the single biggest variable, because everything lowered into the bore — pipe, wire and safety rope — is replaced over the full length. Every contractor prices independently, so treat that as a sanity check on a quote rather than a quote itself.

Cost ranges reported by third parties — reported ranges for well pump in Colorado

Reported cost ranges, 2026. Ranges are published third-party figures, not quotes.
JobReported rangeWhat pushes it higher
Submersible pump, unit only$1,000–$2,500Horsepower, stainless construction and control box requirements for deeper settings.
Shallow jet pump, unit only$450–$1,500Flow demand, a larger pressure tank and freeze protection for the pump house.
Deep well jet pump, unit only$800–$2,200Two-pipe configurations and matching the ejector assembly to well depth.
Well under 25 feet deep$400–$3,000A simple pull and reset unless the casing is damaged or the wiring has failed.
Well 25 to 150 feet deep$1,200–$5,500Drop pipe and wire replaced over the full depth, plus a rig to pull it.
Well over 150 feet deep$2,000–$10,000Heavier equipment, longer wire runs and a constant-pressure controller for the setting.
Labour, pipework and wiring$250–$1,000Depth pulled, corroded fittings that shear and a pressure tank replaced alongside.

Not a quote. These are third-party reported ranges, sourced from Angi, "How Much Does a Well Pump Replacement Cost? [2026 Data]", angi.com/articles/how-much-does-well-pump-replacement-cost.htm, fetched 2026-08-11. Only a licensed contractor who has seen the job can price it.

What moves the number — the 5 factors that change the number

Pricing is set independently by each contractor, so this page lists what moves the number rather than a figure.

  1. 01

    Well depth and pump horsepower

  2. 02

    Submersible versus jet pump

  3. 03

    Whether the pressure tank, wire and control box are replaced with it

  4. 04

    Whether the well cap, casing or wiring has failed

  5. 05

    Water testing and disinfection after the work

Symptoms and triggers — is well pump service actually the fix?

Paying for the wrong job is the most expensive mistake here. These are the signs that point to well pump rather than something else.

  • No water at any fixture on a well system
  • Pump cycles on and off rapidly
  • Sputtering or air in the lines
  • Sediment or cloudiness after pressure changes
  • Pressure switch clicking or a breaker tripping

What the work involves — so a quote can be read line by line

  1. Pressure tank pre-charge and pressure switch are tested first
  2. Amp draw and insulation resistance are checked at the pump
  3. Static and drawdown water level are measured
  4. The pump, wire, pressure tank or switch is replaced as diagnosed
  5. The system is disinfected and flow and pressure verified

Well Pump cost by city in Colorado

Labour rates, permit fees and travel distance all differ across Colorado, which is why the same job is not the same number in every market.

Colorado markets with a dedicated well pump page
CityCountyPermit authority

Before anyone touches a pipe

Verify the licence. It takes two minutes.

  • Who licenses the work: State Plumbing Board, Colorado Division of Professions and Occupations (DORA) together with the local jurisdiction.
  • Who pulls the permit: the licensed contractor, never the homeowner.
  • What to ask for: the licence number, the registered name behind it, and an insurance certificate issued to the property address.
Check a licence numberColorado State Plumbing Board Colorado licensing in full
Chrome faucet with running water
Independent licensed professionals

How to avoid overpaying for well pump

  • Get the scope in writing before the number: what is being replaced, what is being repaired, what is being left alone.
  • Ask whether the price is flat-rate or time-and-materials, and what the diagnostic charge covers.
  • Ask whether the permit and inspection fee is inside or outside the figure.
  • Ask what happens if the job opens up and turns out to be larger — get the change-order rule up front.
  • Confirm the warranty term on parts and on labour separately.
  • Verify the licence number on the Colorado State Plumbing Board register before any work starts.

Answers first

Frequently asked — well pump cost in Colorado

Rapid cycling — pump or tank?

Most often the pressure tank has lost its air charge or the bladder has failed, which makes the pump start and stop constantly and shortens its life quickly. Test the tank before condemning the pump.

How long does a well pump last?

A submersible pump commonly lasts 8–15 years depending on cycling, water chemistry and how well it was sized. Frequent short-cycling is the main thing that shortens it.

Do I need to test the water after pump work?

Yes. Anything that opens the well can introduce contamination. A bacteriological test after disinfection is standard practice and in some jurisdictions required.

Does calling create any obligation to hire?

None. A call or a callback request is a conversation, not a contract. Scope, timing and price are only agreed if you decide to proceed with the professional handling Colorado.

Are night and weekend calls handled differently in Colorado?

Requests route around the clock, but most contractors price after-hours work differently. Ask for the after-hours rate and a committed arrival window before agreeing to a dispatch.

What information speeds up a well pump callback?

Three things: where the water or problem is showing, whether the supply is shut off, and the property type — slab, crawl space or basement. With those, a pro covering Colorado can triage the urgency and bring the right parts.

How should a well pump quote be compared?

Line by line against scope: what is included, what is excluded, who pulls the permit, and whether haul-away and restoration are inside the number. The cost guides on this site list published third-party ranges so any quote can be sanity-checked.

Who handles the permit for well pump in Colorado?

The licensed contractor pulls the permit — never the homeowner. If a contractor proposes skipping a required permit, treat that as the signal to stop and verify the licence.

Get connected

Well Pump in Colorado

The form takes half a minute. It routes to an independent licensed pro covering Colorado; everything else — scope, timing, price — you agree with them directly, licence verified first.

  • Requests handled around the clock
  • An independent licensed pro calls you back
  • No obligation to hire

Prefer a call back?

Takes 30 seconds — an independent licensed pro calls you back.

Records for this request are provided electronically; a paper copy is free on request and the agreement can be withdrawn at any time — electronic records notice.

Submitting without the box still sends the request. PlumberColorado is a referral service, not a plumbing contractor. Stop contact any time